FRONT AXLE HUB (for Sedan) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WHEEL |
| 3. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, release the staked part of the axle hub nut.
Using a 30 mm socket wrench, remove the axle hub nut.
| 4. SEPARATE FRONT SPEED SENSOR (w/ ABS) |
![]() |
Remove the bolt and separate the speed sensor and flexible hose.
![]() |
Remove the bolt and separate the speed sensor from the steering knuckle.
| 5. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the disc brake caliper from the steering knuckle.
| 6. REMOVE FRONT DISC |
![]() |
Place matchmarks on the disc and axle hub and remove the disc.
| 7. SEPARATE TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and castle nut.
![]() |
Install SST (spacer B) to the threaded section of the tie rod end.
Using SST, separate the tie rod end from the front axle assembly.

| 8. SEPARATE FRONT STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the stabilizer link from the shock absorber.
| 9. SEPARATE FRONT SUSPENSION LOWER ARM |
![]() |
Remove the clip and castle nut.
![]() |
Install SST (spacer B) to the threaded section of the lower ball joint.
Using SST, separate the front lower suspension arm from the front axle assembly.

| 10. SEPARATE FRONT AXLE ASSEMBLY |
Using a plastic hammer, tap the end of the drive shaft and disengage the fitting between the drive shaft and front axle.
Push the front axle out of the vehicle to remove the drive shaft from the front axle.
![]() |
Remove the 2 nuts and 2 bolts and remove the front axle assembly.