Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for Sedan)

FRONT AXLE HUB (for Sedan) > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT AXLE HUB BEARING


G031910E01
  1. Using SST and a press, insert a new hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.

    SST
    09950-60020   (09951-00710)
    09950-70010   (09951-07100)

    NOTICE:
    1. Do not remove the inner race because the hub bearing is built into the oil seal.
    2. Do not use bearings that have been removed.
    3. Do not wipe off any grease that has been applied to new bearings.
    4. Do not bring magnets close to the magnetic rotor surface of the bearing.
    5. Keep the magnetic rotor surface of the bearing free of foreign matter.



2. INSTALL FRONT DISC BRAKE DUST COVER


C112273E01
  1. Provisionally install a new disc brake dust cover, as shown in the illustration.



    C116903E01
  1. Using SST and a hammer, install the disc brake dust cover.

    SST
    09223-56010  

    NOTICE:
    1. Uniformly press in the disc brake dust cover while sliding SST slightly.
    2. Surely press in the disc brake dust cover until it comes into contact with the pressing-in base.



    C121846
  1. Using a chisel, fix the 3 points on the circumference.

    NOTICE:
    Securely fold each end into the engagement grooves.



3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY


C107983E01
  1. Using SST and a press, press the axle hub into the steering knuckle.

    SST
    09608-32010  
    09950-60010   (09951-00500)
    09950-70010   (09951-07100)



4. INSTALL FRONT AXLE HUB HOLE SNAP RING


C112581E01
  1. Using snap ring pliers, install a new hole snap ring, as shown in the illustration.

    NOTICE:
    1. Do not overlap the end of the snap ring and the installation hole in the speed sensor on the knuckle side.
    2. Do not damage the magnetic rotor surface of the bearing when installing the snap ring.