REAR AXLE HUB AND BEARING (for Hatchback) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR WHEEL |
| 3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
Release the parking brake and remove the rear brake drum.
If the rear brake drum cannot be removed easily, perform the following procedure.
![]() |
Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, contract the brake shoe by turning the adjusting bolt.
| 4. DISCONNECT SKID CONTROL SENSOR WIRE (w/ ABS) |
![]() |
Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.
| 5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY |
![]() |
Remove the 4 bolts and remove the axle hub and bearing from the axle beam.