Home › ENGINE ยท 2NZ-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan)


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.



3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for Sedan)


B132317
  1. Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end LH.



4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


    B132387
  1. Remove the shift lever knob.



5. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)


C109005E01
  1. Disengage the 6 claws and remove the shifting hole cover.



6. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan)


    B132347
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



7. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER (for Sedan)


    B132348
  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the console upper rear panel.



8. REMOVE CONSOLE BOX CARPET (for Sedan)


B132346
  1. Remove the console box carpet.



9. REMOVE CONSOLE BOX COVER REAR (for Hatchback)


C109006E01
  1. Disengage the 8 claws and remove the console box rear cover.



10. REMOVE CONSOLE BOX ASSEMBLY REAR (for Hatchback)


C116873
  1. Remove the bolt and disengage the 2 clips to remove the console box.



11. REMOVE CONSOLE BOX ASSEMBLY REAR (for Sedan)


    B132349
  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



12. REMOVE INSTRUMENT PAD LOWER LH (for Sedan)


B132339
  1. Remove screw <I>.

  1. Disengage the claw and 3 clips and remove the instrument panel pad lower.



13. REMOVE HEATED OXYGEN SENSOR (for Unleaded Gasoline Specification Vehicle)
  1. Disconnect the sensor connector.

  1. Remove the grommet and pass the sensor connector out of the cabin through the floor panel.



    A115424E01
  1. Using SST, remove the heated oxygen No. 2 sensor.

    SST
    09224-00010  



14. REMOVE EXHAUST PIPE ASSEMBLY FRONT (for Unleaded Gasoline Specification Vehicle)
  1. Remove the 4 bolts and 4 compression springs.



  1. Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.


    A119126

  1. Remove the 2 exhaust pipe gaskets.



15. REMOVE EXHAUST PIPE ASSEMBLY FRONT (for Leaded Gasoline Specification Vehicle)
  1. Remove the 4 bolts and 4 compression springs.



  1. Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.


    A115389

  1. Remove the 2 exhaust pipe gaskets.



16. REMOVE EXHAUST PIPE ASSEMBLY TAIL


  1. Remove the 2 No. 4 exhaust pipe supports and the exhaust tail pipe assembly. (for Hatchback)


    A115390



  1. Remove the 3 No. 4 exhaust pipe supports and the exhaust tail pipe assembly. (for Sedan)


    A133340