Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Hatchback)

ANTI-LOCK BRAKE SYSTEM (for Hatchback) > TERMINALS OF ECU

for Preparation Click here



TERMINALS OF ECU

C156382E01


Terminal No. (Symbol)
Terminal Description
1 (GND1)
Skid control ECU ground
4 (RL-)
Rear wheel speed LH (-) signal input
5 (RL+)
Rear wheel speed LH (+) power supply output
6 (FR-)
Front wheel speed RH (-) signal input
7 (FR+)
Front wheel speed RH (+) power supply output
12 (+BS)
Solenoid relay power supply
13 (GND2)
Pump motor ground
14 (CANL)
CAN communication line L
16 (RR-)
Rear wheel speed RH (-) signal input
17 (RR+)
Rear wheel speed RH (+) power supply output
18 (FL-)
Front wheel speed LH (-) signal input
19 (FL+)
Front wheel speed LH (+) power supply output
22 (SP1)
Speed signal output for speedometer
24 (+BM)
Motor relay power supply
25 (CANH)
CAN communication line H
28 (STP)
Stop light switch input
34 (IG1)
ECU power supply

TERMINAL INSPECTION


  1. Disconnect the connector and measure the voltage or resistance on the wire harness side.


    C168928E02

    HINT:
    Voltage cannot be measured with the connector connected to the skid control ECU as the connector is watertight.


    Standard 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A15-1 (GND1) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    A15-12 (+BS) - Body ground
    W - Body ground
    Solenoid relay power supply
    Always
    11 to 14 V
    A15-13 (GND2) - Body ground
    W-B - Body ground
    Pump motor ground
    Always
    Below 1 Ω
    A15-28 (STP) - Body ground
    G - Body ground
    Stop light switch input
    Stop light switch ON → OFF
    (Brake pedal depressed → released)
    8 to 14 V
    → Below 1.5 V
    A15-24 (+BM) - Body ground
    B - Body ground
    Motor relay power supply
    Always
    11 to 14 V
    A15-25 (CANH) - A15-14 (CANL)
    G - W
    CAN BUS
    Ignition switch off
    54 to 69 Ω
    A15-34 (IG1) - Body ground
    B - Body ground
    ECU power supply
    Ignition switch ON
    11 to 14 V