Home › TRANSMISSION ยท U441E AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > INSPECTION

for Preparation Click here



1. INSPECT STATOR SHAFT ASSEMBLY


C059806
  1. Using a caliper gauge, measure the inside diameter of the stator shaft bush.

    Standard inside diameter:
    18.424 to 18.449 mm (0.7253 to 0.7263 in.)

    Maximum diameter:
    18.449 mm (0.7263 in.)

    If the inside diameter is greater than the maximum, replace the stator shaft assembly.



    C059990
  1. Install the input shaft assembly onto the stator shaft assembly, and check that the input assembly turns smoothly.



2. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


C081414
  1. Using a caliper gauge, measure the inside diameter of the front oil pump body bush.

    Standard inside diameter:
    38.113 to 38.138 mm (1.5005 to 1.5014 in.)

    Maximum diameter:
    38.138 mm (1.5014 in.)

    If the inside diameter is greater than the maximum, replace the front oil pump body assembly.



3. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY


C059809
  1. Check the tip clearance.
    Measure the clearance between the driven gear teeth and drive gear teeth.

    Standard thickness:
    0.07 to 0.15 mm (0.0028 to 0.0059 in.)

    Maximum thickness:
    0.15 mm (0.0059 in.)

    If the thickness is greater than the maximum, replace the oil pump assembly.



    C059810
  1. Check the body clearance.
    Measure the clearance between the driven gear and oil pump body.

    Standard thickness:
    0.10 to 0.17 mm (0.0039 to 0.0067 in.)

    Maximum thickness:
    0.17 mm (0.0067 in.)

    If the thickness is greater than the maximum, replace the oil pump assembly.



    C059811
  1. Check the side clearance.
    Using a steel straight edge and feeler gauge, measure the side clearance of both gears.

    Standard thickness:
    0.02 to 0.05 mm (0.0008 to 0.0020 in.)

    Maximum thickness:
    0.05 mm (0.0020 in.)

    If the thickness is greater than the maximum, replace the oil pump assembly.