BRAKE MASTER CYLINDER (for Sedan LHD) > INSTALLATION |
| 1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD |
![]() |
Set SST on the master cylinder and lower the rod of SST until it just touches the piston.
Apply chalk to the flat tip of the SST rod. Turn SST upside down and measure the clearance between the brake booster push rod and SST.
![]() |
If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.
| 2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY |
Install a new O-ring onto the brake master cylinder sub-assembly.
![]() |
w/ ABS:
Install the brake master cylinder sub-assembly with the 2 nuts.
![]() |
w/o ABS:
Install the brake master cylinder sub-assembly and brake tube way with the 2 nuts.
![]() |
Using SST, install the 2 brake tubes onto the brake master cylinder sub-assembly.
![]() |
w/o ABS:
Using SST, install the 3 brake tubes to the brake tube way.
Connect the brake fluid level warning switch connector.
| 3. CONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle) |
![]() |
Connect the reservoir tube with the clip.
| 4. INSTALL BATTERY CARRIER |
| 5. INSTALL BATTERY TRAY |
| 6. INSTALL BATTERY |
| 7. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
Remove the cowl top No. 2 ventilator louver center.
![]() |
Set the brake fluid can upside down on the reservoir.
| 8. BLEED MASTER CYLINDER |
![]() |
Using a union nut wrench (10 mm), disconnect the brake tubes from the master cylinder.
![]() |
Slowly depress the brake pedal and hold it there (Step A).
![]() |
Block the outer holes with your fingers, and release the brake pedal (Step B).
Repeat steps A and B 3 or 4 times.
![]() |
Using a union nut wrench (10 mm), connect the brake tubes to the master cylinder.
| 9. BLEED BRAKE LINE |
![]() |
Connect the vinyl tube to the bleeder plug.
Depress the brake pedal several times, then loosen the bleeder plug with the pedal depressed (Step C).
At the point where the fluid stops coming out, tighten the bleeder plug, then release the brake pedal (Step D).
Repeat steps C and D until all the air in the fluid is completely bled out.
Tighten the bleeder plug.
Repeat the above procedure to bleed the air out of the brake line for each wheel.
| 10. CHECK FLUID LEVEL IN RESERVOIR |
Check the fluid level and add fluid if necessary.
| 11. CHECK FOR BRAKE FLUID LEAKAGE |