Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (for Sedan LHD)

BRAKE MASTER CYLINDER (for Sedan LHD) > REMOVAL

for Preparation Click here


NOTICE:
Release the vacuum from booster by depressing the brake pedal several times.
Then remove the brake master cylinder from brake booster.



1. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



2. REMOVE BATTERY


3. REMOVE BATTERY TRAY


4. REMOVE BATTERY CARRIER


5. DISCONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle)


C116933
  1. Slide the clip and disconnect the reservoir tube.



6. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
  1. Disconnect the brake fluid level warning switch connector.



  1. w/o ABS:



      C121832E01
    1. Using SST, separate the 3 brake tubes from the brake tube way.

      SST
      09023-00100  



    C121690E01
  1. Using SST, separate the 2 brake tubes from the brake master cylinder sub-assembly.

    SST
    09023-00100  



    C116934
  1. w/ ABS:

    1. Remove the 2 nuts and remove the brake master cylinder sub-assembly.



    C121833
  1. w/o ABS:

    1. Remove the 2 nuts and brake tube way and remove the brake master cylinder sub-assembly.

  1. Remove the O-ring from the brake master cylinder sub-assembly.

    NOTICE:
    1. The master cylinder requires careful handling. Do not allow the master cylinder to receive any impact, such as from being dropped. Do not reuse a master cylinder that has been dropped.
    2. Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.
    3. Release the vacuum from booster by depressing the brake pedal several times. Then remove the brake master cylinder from brake booster.
    4. When installing the brake master cylinder sub-assembly onto the brake booster, or when removing the brake master cylinder sub-assembly from the brake booster, make sure that the brake master cylinder sub-assembly is kept horizontal or its tip faces downward (the piston faces upward) to prevent the master cylinder piston from falling off.
    5. Do not allow any foreign objects to contaminate the master cylinder piston. If a foreign object gets on the piston, remove it by using a piece of cloth and then apply an even layer of lithium soap based glycol grease around the circumference (sliding part) of the piston.
    6. Do not use any other type of grease or fluid.