Home › ENGINE · 1NZ-FE › STARTING › INTEGRATION RELAY

INTEGRATION RELAY > INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION NO.1 RELAY


A107023E05
  1. Inspect AM2 (15A) fuse.

    1. Disconnect the fuse. Using an ohmmeter, measure the resistance of the fuse.

      Standard resistance:
      Tester Connection
      Specified condition
      1 - 2
      Below 1 Ω

  1. Inspect IG2 relay.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified condition
      B1 - C1
      Below 1 Ω
      B1 - B4
      Below 1 Ω
      (Apply battery voltage between terminals B2 and B3)
      10 kΩ or higher
      B4 - C1
      Below 1 Ω
      (Apply battery voltage between terminals B2 and B3)
      10 kΩ or higher

      NOTICE:
      While using the battery for inspections, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.