PROPORTIONING VALVE (for Hatchback) > INSTALLATION |
| 1. INSTALL PROPORTIONING VALVE |
![]() |
Install the proportioning valve onto the proportioning valve bracket with the 2 nuts.
![]() |
Install the 2 bolts onto the proportioning valve bracket in the sequence shown in the illustration.
![]() |
Using SST, install the 5 brake tubes into the proportioning valve.
| 2. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
LHD:
Disengage the 3 clips and separate the hood to cowl top seal.
Remove the cowl top ventilator louver.
RHD:
Disengage the 2 clips and separate the hood to cowl top seal.
Remove the cowl top ventilator louver.
![]() |
Set the brake fluid can upside down on the reservoir.
| 3. BLEED MASTER CYLINDER |
![]() |
Using a union nut wrench (10 mm), disconnect the brake tubes from the master cylinder.
![]() |
Slowly depress the brake pedal and hold it there (Step A).
![]() |
Block the outer holes with your fingers, and release the brake pedal (Step B).
Repeat steps A and B 3 or 4 times.
![]() |
Using a union nut wrench (10 mm), connect the brake tubes to the master cylinder.
| 4. BLEED BRAKE LINE |
![]() |
Connect the vinyl tube to the bleeder plug.
Depress the brake pedal several times, then loosen the bleeder plug with the pedal depressed (Step C).
At the point where the fluid stops coming out, tighten the bleeder plug, then release the brake pedal (Step D).
Repeat steps C and D until all the air in the fluid is completely bled out.
Tighten the bleeder plug.
Repeat the above procedure to bleed the air out of the brake line for each wheel.
| 5. CHECK FLUID LEVEL IN RESERVOIR |
Check the fluid level and add fluid if necessary.
| 6. CHECK FOR BRAKE FLUID LEAKAGE |