Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > IG Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the main power source supplied to the air conditioning amplifier when the ignition switch is turned on (IG). This power source is used for operating components such as the air conditioning amplifier.

WIRING DIAGRAM


E118639E04


INSPECTION PROCEDURE

HINT:
Start the engine before the inspection. Check the IG1 relay or battery if the engine does not start.

1.INSPECT FUSE (A/C)
  1. Remove the A/C fuse from the main body ECU.

  1. Measure the resistance.

Standard resistance:
Below 1 Ω

  1. Reinstall the A/C fuse.



NG
REPLACE FUSE
OK


2.INSPECT AIR CONDITIONING AMPLIFIER
E142753E01
  1. Disconnect the E8 air conditioning amplifier connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E8-8 (IG+) - E8-12 (GND)
    Ignition switch on (IG)
    11 to 14 V

  1. Reconnect the air conditioning amplifier connector.



NG
Go to step 3
OK

REPLACE AIR CONDITIONING AMPLIFIER 

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - MAIN BODY ECU)
E142754E02
  1. Disconnect the E8 air conditioning amplifier connector.

  1. Disconnect the 4S main body ECU connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E8-8 (IG+) - 4S-10
    Below 1 Ω

  1. Reconnect the air conditioning amplifier connector.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND)
E142753E03
  1. Disconnect the E8 air conditioning amplifier connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E8-12 (GND) - Body ground
    Below 1 Ω

  1. Reconnect the air conditioning amplifier connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE