Home › ENGINE ยท 2NZ-FE › EMISSION CONTROL › CANISTER

CANISTER > DISASSEMBLY

for Preparation Click here



1. REMOVE FUEL SENDER GAUGE ASSEMBLY


A159406

NOTICE:
Do not separate the tube indicated in the illustration.



    A105590
  1. Disconnect the fuel sender gauge connector.



    A119156
  1. Release the lock by sliding the fuel sender gauge upward, as shown in the illustration.



2. REMOVE FUEL PUMP


    A105592
  1. Disconnect the connector of the fuel pump harness.



    A109341
  1. Disconnect the fuel tube.



    A119168
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, and remove the fuel filter and the fuel pump from the fuel sub-tank.



    A119157
  1. Disengage the 2 claws and remove the fuel suction support.



    A180183E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the suction filter with fuel pump from the fuel filter.

    NOTICE:
    1. Do not damage the fuel filter and suction filter.
    2. Do not remove the suction filter from the fuel pump.
    3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.



    A171289
  1. Disconnect the fuel pump harness.



    A171292E03
  1. Remove the O-ring and fuel pump spacer.



3. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A119158
  1. Using a screwdriver with its tip wrapped in protective tape, remove the pressure regulator assembly.



    A119159
  1. Remove the 2 O-rings.



4. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


    A119160
  1. Remove the retainer ring.



    A119161
  1. Remove the fuel sub-tank.



    A119162
  1. Remove the spring.