Home › ENGINE ยท 1NZ-FE › EMISSION CONTROL › CANISTER

CANISTER > REASSEMBLY

for Preparation Click here



1. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY


    A119162
  1. Install the spring.



    A119161
  1. Install the fuel sub-tank.



    A119160
  1. Install a new retainer ring.



2. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    A119159
  1. Apply gasoline to 2 new O-rings.



    A119158
  1. Install the pressure regulator assembly.



3. INSTALL FUEL PUMP


    A171292E03
  1. Apply gasoline to a new O-ring, and then install the fuel pump spacer and new O-ring onto the fuel pump.

    NOTICE:
    Do not disassemble the fuel pump and the suction filter because they are nonreusable parts.



    A171289
  1. Connect the fuel pump harness.



    A180183E01
  1. Engage the 5 claws of the suction filter with fuel pump.

    NOTICE:
    1. Do not remove the suction filter from the fuel pump.
    2. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.



    A119157
  1. Engage the 2 claws of the fuel suction support.



    A119168
  1. Engage the 2 claws of the fuel suction support and install the fuel filter and fuel pump onto the fuel sub-tank.



    A109341
  1. Connect the fuel tube.



    A105592
  1. Connect the connector of the fuel pump harness.



4. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A119165
  1. Install the fuel sender gauge by sliding it downward.



    A105590
  1. Connect the fuel sender gauge connector.