Home › BODY › EXTERIOR › REAR SPOILER (for Sedan)

REAR SPOILER (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL REAR SPOILER PROTECTOR SIDE LH


B134854

NOTICE:
Follow these procedures only when replacing the protector.

  1. Apply a new rear spoiler protector to the rear spoiler installation surface as shown in the illustration.



2. INSTALL REAR SPOILER PROTECTOR SIDE RH

HINT:
Use the same procedure as for the LH side.



3. INSTALL REAR SPOILER SUB-ASSEMBLY


  1. Clean the rear spoiler (When reusing the rear spoiler).

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the rear spoiler while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided adhesive tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using non-residue solvent, clean the rear spoiler.



    4. B134855
    5. Apply new double-sided adhesive tape to the rear spoiler installation surface as shown in the illustration.

  1. Clean the attachment surface.

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the luggage compartment door panel while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided adhesive tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using non-residue solvent, clean the attachment surface.



    B134853
  1. Install the wire harness into the luggage compartment door panel hole.

  1. Engage the 2 clips and install the rear spoiler.

  1. Remove the protective tape.



    B134851
  1. Tighten the 2 bolts.

  1. Connect the center stop light connector.