Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Sedan)

FRONT SEAT OUTER BELT ASSEMBLY (for Sedan) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



2. REMOVE FRONT DOOR SCUFF PLATE


    B134764
  1. Disengage the 11 claws and remove the front door scuff plate.



3. REMOVE REAR DOOR SCUFF PLATE


    B134771
  1. Disengage the 7 claws and remove the rear door scuff plate.



4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP


    B138445
  1. Detach the front door opening trim weatherstrip sufficiently to remove the upper and lower center pillar garnishes.



5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP


    B138446
  1. Detach the rear door opening trim weatherstrip sufficiently to remove the upper and lower center pillar garnishes.



6. REMOVE CENTER PILLAR LOWER GARNISH


    B134767
  1. Disengage the 3 claws and 2 clips and remove the center pillar lower garnish.



7. REMOVE SEAT BELT ANCHOR COVER CAP


    B114421E01
  1. Pull portion A, shown in the illustration, toward you, remove the 2 claws on the lower side followed by the claw on the upper side. Then remove the seat belt anchor cover cap.



8. REMOVE LAP BELT OUTER ANCHOR COVER


    B134891
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B134892
  1. Remove the bolt and the anchor plate.



    B114296
  1. Remove the bolt and the shoulder anchor.



  1. Disconnect the pretensioner connector.



      B134893E01
    1. Using a screwdriver, release the locking button.

    2. Using a screwdriver, disconnect the pretensioner connector.



    B134896
  1. Remove the 2 bolts, the 2 hooks and the retractor.



10. REMOVE CENTER PILLAR UPPER GARNISH


    B134768
  1. Disengage the 2 clips and 2 hooks and remove the center pillar upper garnish.



11. REMOVE SHOULDER BELT ANCHORAGE PLATE COVER


    B134897
  1. Disengage the 2 claws and remove the shoulder belt anchorage plate cover.



12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B134898
  1. Remove the 2 bolts, the hook and the front shoulder belt anchor adjuster.