POWER WINDOW REGULATOR MOTOR (for Sedan Rear Side) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR DOOR ARMREST BASE UPPER PANEL |
![]() |
Disengage the 4 claws and remove the rear door armrest base upper panel.
| 3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Remove the screw.
![]() |
Disengage the 7 clips.
![]() |
Disconnect the rear door lock remote control cable and rear door inside locking cable and remove the rear door trim board.
| 4. REMOVE REAR DOOR TRIM BRACKET |
![]() |
Remove the 2 screws and the rear door trim bracket.
| 5. REMOVE REAR DOOR SERVICE HOLE COVER |
![]() |
Disconnect the connectors and clamps, then remove the rear door service hole cover.
| 6. REMOVE REAR DOOR CHECK ASSEMBLY |
![]() |
Remove the 3 bolts, then remove the rear door check.
| 7. REMOVE REAR DOOR WEATHERSTRIP |
![]() |
Disengage the 32 clips and remove the rear door weatherstrip.
| 8. REMOVE REAR DOOR BELT MOULDING |
![]() |
Apply protective tape to the door panel in the periphery of the rear door belt moulding.
![]() |
Using a moulding remover, disengage the 5 claws and remove the rear door belt moulding.
| 9. REMOVE REAR DOOR GLASS RUN |
![]() |
Remove the rear door glass run.
| 10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY |
![]() |
Remove the 2 bolts, screw and rear door window division bar.
| 11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
w/ Power window:
Remove the rear door glass from the rear door window regulator.
![]() |
w/o Power window:
Remove the rear door glass from the rear door window regulator.
| 12. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY |
![]() |
w/ Power window:
Disconnect the connector.
Loosen bolt A.
Remove the 3 bolts, then remove the rear door window regulator.
![]() |
w/o Power window:
Remove the 3 bolts, then remove the rear door window regulator.
| 13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY REAR |
![]() |
Using "TORX" socket wrench T25, remove the 3 screws and power window regulator motor.