Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Sedan)

FRONT SEAT INNER BELT ASSEMBLY (for Sedan) > INSPECTION

for Preparation Click here


HINT:
The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY


    B117729E01
  1. for Driver Side:

    1. Check the resistance.

      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard resistance:
        Tester Connection
        Condition
        Specified Condition
        1 - 2
        Tongue plate fastened
        10 kΩ or higher
        Tongue plate released
        Below 1 Ω

        If the result is not as specified, replace the front seat inner belt.



    B138526E01
  1. for Front Passenger Side:

    1. Check the resistance.

      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard resistance:
        Tester Connection
        Condition
        Specified Condition
        A1 - B3
        Tongue plate fastened
        10 kΩ or higher
        Tongue plate released
        Below 1 Ω
        A2 - B1
        Always
        Below 1 Ω

        If the result is not as specified, replace the front seat inner belt.