Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Sedan)

FRONT SEAT INNER BELT ASSEMBLY (for Sedan) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).



2. REMOVE FRONT SEAT HEADREST ASSEMBLY


    B138314E01
  1. Push in the lock button of the front seat headrest support and remove the front seat headrest.



3. REMOVE FRONT SEAT ASSEMBLY


    B138315E01
  1. w/ Front Seat Side Airbag:

    1. Slide the slider and disconnect the airbag connector.

  1. Disconnect the buckle switch connector.



    B138317
  1. Move the front seat to its most rearward position.

  1. Using "TORX" socket wrench E10, remove the 2 bolts from the front side.

  1. Move the front seat to its most forward position.

  1. Using "TORX" socket wrench E10, remove the 2 bolts from the rear side and the front seat.



4. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    B138350
  1. for Driver Side:

    1. Disengage the claw and remove the connector.

    2. Remove the 2 clamps.

    3. Using a clip remover, remove the clamp.



    B138353
  1. for Front Passenger Seat:

    1. Disconnect the occupant detection sensor connector.

    2. Disengage the claw and remove the connector.

    3. Remove the 2 clamps.

    4. Using a clip remover, remove the clamp.



    B138351
  1. Remove the wire harness from the claw of the front seat cushion inner shield.

  1. Remove the nut and the front seat inner belt.