Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter

for Preparation Click here


DESCRIPTION

This circuit is necessary for the ASL (Auto Sound Leveliser) built into the radio receiver.
Speed signals are received from the combination meter and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable the audio sound to be heard clearly even when vehicle noise increases (as vehicle noise increases, the volume is turned up etc.).

WIRING DIAGRAM


C138627E01


INSPECTION PROCEDURE

1.CHECK SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer on the combination meter is normal.

    OK:
    The actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
CHECK COMBINATION METER
OK


2.INSPECT RADIO RECEIVER


    C138628E01
  1. Disconnect radio receiver connector D53.



  1. Measure the voltage.

    1. Jack up either one of the drive wheels.

    2. Move the shift lever to the neutral position.

    3. Turn the ignition switch to ON.



    4. E110855E04
    5. Measure the voltage between terminal SPD of the radio receiver connector and the body ground when the drive wheel is turned slowly.

      OK:
      Voltage pulses as shown in the illustration.



NG
Go to step 3
OK

REPLACE RADIO RECEIVER 

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - RADIO RECEIVER)


    C138629E01
  1. Disconnect radio receiver connector D53 and combination meter connector D1.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D53-3 (SPD) - D1-16 (4P OUT)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - RADIO RECEIVER)


    C138629E01
  1. Disconnect radio receiver connector D53 and combination meter connector D1.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D53-3 (SPD) - Body ground
    Always
    10 kΩ or higher

    HINT:
    If the resistance between terminal SPD and the body ground is less than 10 kΩ, there may be a short in a wire harness, connector, or an ECU that is connected to the SPD signal wire.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
OK

REPLACE COMBINATION METER