AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver |

| 1.INSPECT RADIO RECEIVER |
![]() |
Disconnect the D88 radio receiver connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D88-3 (MACC) - Body ground | Ignition switch ON | 4 to 6 V |
| D88-1 (SNS2) - Body ground |
Reconnect the radio receiver connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO RECEIVER) |
![]() |
Disconnect the K3 microphone amplifier connector.
Disconnect the D88 radio receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K3-1 (MACC) - D88-3 (MACC) | Always | Below 1 Ω |
| K3-2 (MIC+) - D88-2 (MIN+) | ||
| K3-3 (SNS2) - D88-1 (SNS2) | ||
| K3-4 (MIC-) - D88-5 (MIN-) | ||
| K3-1 (MACC) - Body ground | Always | 10 kΩ or higher |
| K3-2 (MIC+) - Body ground | ||
| K3-3 (SNS2) - Body ground | ||
| K3-4 (MIC-) - Body ground |
Reconnect the microphone amplifier connector.
Reconnect the radio receiver connector.
|
| ||||
| OK | ||
| ||