Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the microphone to the radio receiver.
It also supplies power from the radio receiver to the microphone.

WIRING DIAGRAM


E170649E01


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER


    E170647E01
  1. Disconnect the D88 radio receiver connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D88-3 (MACC) - Body ground
    Ignition switch ON
    4 to 6 V
    D88-1 (SNS2) - Body ground

  1. Reconnect the radio receiver connector.



NG
REPLACE RADIO RECEIVER (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO RECEIVER)


    E170648E01
  1. Disconnect the K3 microphone amplifier connector.

  1. Disconnect the D88 radio receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K3-1 (MACC) - D88-3 (MACC)
    Always
    Below 1 Ω
    K3-2 (MIC+) - D88-2 (MIN+)
    K3-3 (SNS2) - D88-1 (SNS2)
    K3-4 (MIC-) - D88-5 (MIN-)
    K3-1 (MACC) - Body ground
    Always
    10 kΩ or higher
    K3-2 (MIC+) - Body ground
    K3-3 (SNS2) - Body ground
    K3-4 (MIC-) - Body ground

  1. Reconnect the microphone amplifier connector.

  1. Reconnect the radio receiver connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)