Home › ENGINE · 2NZ-FE › LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A104877
  1. Disconnect the engine oil pressure switch connector.

  1. Start the engine.



    A166069E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Switch body
    Engine Stopped
    Below 1 Ω
    1 - Switch body
    Engine Idling
    10 kΩ or higher

    HINT:
    If the result is not as specified, replace the engine oil pressure switch assembly.