Home › BODY ELECTRICAL › LIGHTING › SIDE TURN SIGNAL LIGHT ASSEMBLY (for Outer Rear View Mirror)

SIDE TURN SIGNAL LIGHT ASSEMBLY (for Outer Rear View Mirror) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE OUTER MIRROR


B136241E01
  1. Apply protective tape to the lower part of the mirror body.

  1. Press down the upper part of the mirror and tilt the mirror.

  1. Insert a moulding remover into the 2 clip installation positions on the lower part of the mirror to disengage the 2 clips.

  1. Remove the mirror by pulling it downward.



2. REMOVE OUTER MIRROR COVER


    B209239
  1. Disengage the 7 claws from the inside of the mirror body.

  1. Push the upper part of the mirror cover forward to tilt it, and then disengage the claw on the lower part to remove the outer mirror cover.



3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


E151453
  1. Remove the 3 screws.

  1. Disconnect the connector and remove the side turn signal light.