DTC C1417 High Power Supply Voltage Malfunction |
| DTC NO. | DTC Detection Condition | Trouble Area |
| C1417 | The IG1 terminal voltage is more than 17.4 V for 0.8 seconds or more. |
|
| 1.INSPECT BATTERY |
Inspect the battery voltage.
| Result | Proceed to |
| OK | A |
| NG (for 2NZ-FE) | B |
| NG (for 1NZ-FE) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (IG1 TERMINAL) |
![]() |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the A76 brake actuator assembly (skid control ECU) connector.
Check the connector case and terminals for deformation and corrosion.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A76-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Brake Actuator Assembly (Skid Control ECU)) |
Reconnect the A76 brake actuator assembly (skid control ECU) connector.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTCs (Click here).
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC (C1417) is not output | A |
| DTC (C1417) is output | B |
|
| ||||
| A | ||
| ||