WORK NOTICES AND PRECAUTIONS > PRECAUTIONS FOR SRS AIRBAG SYSTEM



HANDLING OF A VEHICLE THAT HAS BEEN DAMAGED IN A COLLISION
  1. Refer to the TOYOTA Repair Manual for the SRS airbag system inspection procedures.

  2. If impacts are likely to occur to the front airbag sensors, side airbag sensors, rear airbag sensors or center airbag sensor remove each sensor as necessary beforehand.

  3. Do not allow the front airbag sensors, side airbag sensors, rear airbag sensors or center airbag sensor to become heated to high temperatures.

  4. Check the wire harnesses and connectors for damage and/or melting, as some areas of the airbags and seat belt pretensioners may heat up to several hundred degrees when they operate.


PRECAUTIONS FOR USING ELECTRIC WELDER
  1. Check the Diagnostic Trouble Codes (DTCs).

    1. If one or more DTCs are displayed;

      1. Disconnect the negative (-) terminal cable from the battery.
      2. Disconnect all the malfunctioning circuit connectors.
      3. Disconnect the center airbag sensor assembly connector.

    2. If DTCs are NOT displayed;

      1. Inspect for damage to the electric wiring harnesses and connectors.
      2. Disconnect the negative (-) terminal cable from the battery.
      3. Disconnect the center airbag sensor assembly connector.


PARTS LOCATION


  1. w/ VSC for Europe:


    B279062E03


    B279063E03


    B279061E06


    C234026E05



  2. w/ VSC except Europe:


    C242988E02


    B279061E07


    C234026E06



  3. w/o VSC for Europe:


    C241495E03


    C241496E03


    C241498E03


    C241497E03



  4. w/o VSC except Europe:


    C243175E02


    C243176E02


    C243178E02


    C243177E02