FRONT BODY PILLAR > CUT AND JOIN REPLACEMENT SECTIONS



  1. K100688
    With the cowl top side upper panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100015
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disc Sander etc.
K100023
Cut and Join Location
K100024
Cut Location for Supply Parts
REMOVAL POINT
  1. Carefully cut the rocker reinforce outer so not to damage *1.
  2. *2 indicates the location of the foamed sealing material. Be careful when cutting as the foamed sealing material is located near the cutting position.

K101570E01


K101571E01


INSTALLATION

Symbol meaning
K100014
Remove Weld Points
K100017
Spot Weld
K100019
Plug Weld
K100020
Plug Weld
K100021
Plug Weld
K100023
Cut and Join Location
K100026
Fillet Weld
K100027
Butt Weld
K100030
Body Sealer
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. If the entire supply part is not needed, remove the part of the supply part that is needed.
  4. Before installing a new part, apply body sealer.

    HINT:
    Apply body sealer in an even, continuous bead.

  5. Before temporarily installing the new parts, weld the rocker reinforce outer, front body pillar reinforce lower, front body pillar inner and front body pillar upper outer with the standard number of welding points.
  6. When welding *1, make a hole on a new part for plug welding and weld the panel with the panel.
  7. *2 indicates the location of the foamed sealing material. Be careful when welding as the foamed sealing material is located near the area that is cut and joined together.
  8. After welding the rocker reinforce outer, front body pillar reinforce lower, front body pillar inner and front body pillar upper outer to the vehicle side, install the *3.
  9. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)
  10. After welding, apply body sealer to the corresponding parts. (See the painting / coating)
  11. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101572E01


K101573E01


K101574E01