CENTER BODY PILLAR (for 3 Door) > CUT AND JOIN REPLACEMENT SECTIONS



  1. K101564
    With the quarter panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points
K100023
Cut and Join Location
REMOVAL POINT
  1. *1 is reused.

K101575E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100021
Plug Weld
K100023
Cut and Join Location
K100027
Butt Weld
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. If the entire supply part is not needed, remove the part of the supply part that is needed.
  4. Before temporarily installing the new parts, weld the center body pillar reinforcement and No.1 inner pillar with the standard number of welding points.
  5. After welding the center body pillar reinforcement and No.1 inner pillar to the vehicle side, install the *1.
  6. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)
  7. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101576E01


K101577E01