ROCKER PANEL (for 3 Door) > CUT AND JOIN REPLACEMENT SECTIONS



  1. K101567
    With the quarter panel removed.
  1. Weld work for 980 MPa ultra high strength steel
Follow the welding conditions below when welding ultra high strength steel to assure sufficient weld strength. (When repairing this model)
  1. *1: When welding 2 panels together including 980 MPa ultra high strength steel.

    Spot weld
    Pressure
    2940 N (300 kgf, 661 lbf)
    Weld current
    10000 A
    Weld time
    14 Cyc. (0.23 Sec.)
    Plug weld
    Plug diameter
    10 mm (0.39 in.)
    Wire type
    AWS A5.18 ER70S-3
    Shield gas
    Metal active gas
  1. *2: When welding more than 3 panels together including 980 MPa ultra high strength steel. (When plug welding a third panel to 2 panels which are welded under the conditions described above.)

    Plug weld
    Plug diameter
    Same as the standard method (See the introduction)
    Wire type
    AWS A5.18 ER70S-3
    Shield gas
    Metal active gas

NOTICE:
Be sure to use Metal active gas (Ar 80% + CO2 20%) as the shield gas when plug welding. Sufficient weld strength cannot be assured when using 100% CO2 shield gas.


REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disc Sander etc.
K100023
Cut and Join Location
K100024
Cut Location for Supply Parts
REMOVAL POINT
  1. Do not butt weld or heat repair because the heat decreases the strength of areas where ultra high strength steel is used. (See the introduction)
  2. Reuse *3, as the area of the outer panel that is cut and joined is in front of the supplied part cut position.

K101591E01


K101592E01


INSTALLATION

Symbol meaning
K100016
Remove Weld Points
K100017
Spot Weld
K100019
Plug Weld
K100021
Plug Weld
K100023
Cut and Join Location
K100026
Fillet Weld
K100027
Butt Weld
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. If the entire supply part is not needed, remove the part of the supply part that is needed.
  4. Carefully cut the rocker reinforce outer so not to damage *3.
  5. Follow the welding conditions when welding *1 and *2 to assure sufficient weld strength. (See the introduction)
  6. Before temporarily installing the new parts, weld the rocker reinforce outer, center body pillar reinforcement and No.1 inner pillar with the standard number of welding points.
  7. After welding the rocker reinforce outer, center body pillar reinforcement and No.1 inner pillar to the vehicle side, install the rocker panel outer and *4.
  8. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101593E01


K101594E01


K101595E01


K101596E01