REAR FLOOR SIDE MEMBER > CUT AND JOIN REPLACEMENT SECTIONS



  1. K100579
    With the body lower back panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points
K100023
Cut and Join Location
REMOVAL POINT
  1. After removing the floor side rail panel FR, remove the rear floor side member or rear floor side member front.

K101550E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100021
Plug Weld
K100027
Butt Weld
INSTALLATION POINT
  1. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  2. After welding the rear floor side member or rear floor side member front to the vehicle side, install the floor side rail panel FR.
  3. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  4. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101551E01