ROOF PANEL (for Glass Roof) > ASSEMBLY REPLACEMENT


K101520

REMOVAL

Symbol meaning
K100014
Remove Weld Points

K101554E01


INSTALLATION

Symbol meaning
K100017
Spot Weld
K100019
Plug Weld
K100030
Body Sealer
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. After the roof panel reinforcement is welded to the new parts, install the roof panel rear to the vehicle side.
  4. Before temporarily installing the new parts, apply body sealer to the roof panel reinforcement and back door opening frame.

    HINT:
    Apply just enough body sealer for the new parts to make contact.

  5. After welding, apply body sealer to the corresponding parts. (See the painting / coating)
  6. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101555


K101554E02