NAME PLATE > ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    HINT:
    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    NOTICE:
    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    HINT:
    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.


Reference Value 
Area
Measurement
Area
Measurement
*a
223.8 mm (8.81 in.)
*b
211.9 mm (8.34 in.)
*c
167.1 mm (6.58 in.)
*d
215.8 mm (8.50 in.)
*e
220.0 mm (8.66 in.)
*f
51.5 mm (2.03 in.)

B283000E01


K101853E01