WIRELESS DOOR LOCK CONTROL SYSTEM > DETAILS



FUNCTION OF MAIN COMPONENTS
  1. The main components in the wireless door lock control system have the following functions:

    Component
    Function
    Door Lock with Motor Assembly
    Door Lock Motor
    Drives the motor in response to signals from the main body ECU (multiplex network body ECU) and locks or unlocks the doors.
    Door Lock Position Switch
    Detects whether the doors are locked or unlocked and sends this information to the main body ECU (multiplex network body ECU).
    Back Door Lock Assembly
    Door Lock Motor
    Drives the motor in response to signals from the main body ECU (multiplex network body ECU) and releases the back door latch.
    Back Door Courtesy Light Switch
    Detects whether the back door is open or closed and sends this information to the main body ECU (multiplex network body ECU).
    Door Courtesy Light Switch Assembly
    Detects whether the doors are open or closed and sends this information to the main body ECU (multiplex network body ECU).
    Door Control Receiver
    Receives a lock or unlock signal from the transmitter and sends this information to the main body ECU (multiplex network body ECU).
    Main Body ECU (Multiplex Network Body ECU)
    Drives all door lock motors in response to signals.
    Combination Meter Assembly
    Receiving the main body ECU (multiplex network body ECU) signals causes to blink the hazard light as an answer back.
    Door Control Transmitter
    Sends the ID code and function code to the door control receiver.


FUNCTION
  1. The wireless door lock control system has the following functions:

    Function
    Outline
    Customized*
    All Doors Lock
    Pressing the "lock" button of the door control transmitter locks all doors and back door.
    Not Available
    All Doors Unlock
    Pressing the "unlock" button of the door control transmitter unlocks all doors and back door.
    Not Available
    Automatic Lock
    If none of the doors are opened for 30 seconds after being unlocked by the wireless door lock control, all the doors are locked again automatically.
    Available
    Answer Back
    The hazard light blinks once when locking, and blinks twice when unlocking, to inform that the operation has been completed.
    Available

    HINT:
    *: Customizable parameters can be configured by means of the customized body electronics system. For details, refer to the Repair Manual.


DIAGNOSIS
  1. If there is a malfunction in the system, the main body ECU (multiplex network body ECU) stores the Diagnostic Trouble Codes (DTCs) in its memory. For details, refer to the Repair Manual.