WIPER AND WASHER SYSTEM > DETAILS |
| FUNCTION OF MAIN COMPONENTS |
The wiper and washer system consists of the following parts:
| Component | Function |
| Windshield Wiper Switch Assembly | Outputs the switch position signal to the windshield wiper motor assembly and the rear wiper motor assembly. |
| Windshield Wiper Motor and Link Assembly | Activates the front wiper arm and blade assembly in accordance with position signal of the windshield wiper switch assembly. |
| Rear Wiper Motor Assembly | Activates the rear wiper in accordance with the position signal of the windshield wiper switch assembly. |
| Windshield Washer Jar Assembly | Activates the windshield washer motor and pump assembly and rear washer motor and pump assembly in accordance with the signal from the washer switch. |
| SYSTEM CONTROL |
Washer-linked Wiper
When the wiper and washer switch is set to off and the washer switch is turned on for approximately 0.5 seconds or more, the wiper start operating in low speed at the same time as the washer fluid is sprayed.
The wiper operates 3 times in low speed after the washer switch is turned off.

| CONSTRUCTION |
Front Wiper Arm and Blade Assembly
The front wiper arm and blade assembly consists of a front wiper arm, front wiper blade, sub arm and swivel.
A pantograph mechanism, in which the sub arm and swivel have been added, is used in the front wiper arm. As a result, the lower portion of the wiper blade will move like it is pushed out around the position where the front wiper arm reverses, expanding the wipe-off area to the bottom corner on the driver side.

| *1 | Front Wiper Arm | *2 | Sub Arm |
| *3 | Swivel | *4 | Front Wiper Blade |
| *a | When the pantograph mechanism is used. | *b | When the pantograph mechanism is not used. |
![]() | Expanded wipe-off area | - | - |
Windshield Wiper Motor Assembly
The motor used in the windshield wiper motor assembly has been changed from a generally employed 2-pole motor to a 4-pole motor to reduce the yoke and magnet thickness, achieving a more compact and lightweight form.

| *A | 2-pole Motor | *B | 4-pole Motor |
| *1 | Windshield Wiper Motor | *2 | Yoke |
| *3 | Magnet | - | - |
| *a | A-A Cross Section | - | - |
Windshield Washer Nozzle
A windshield washer nozzle has been mounted on the front wiper arm head to spray washer fluid in the direction from the lower end to the upper end of the front wiper blade so that the minimum area along the wiper blade will be sprayed. Due to this, a reduction in view obstruction when spraying and fluid spread when driving at high speeds has been achieved, meanwhile, good wiping performance with a small amount of washer fluid will also be delivered.

| *1 | Windshield Washer Nozzle | *2 | Front Wiper Arm Head |
![]() | Sprayed area | - | - |
Rear Washer Nozzle
Spray type rear washer nozzles are located on the back door panel.

| *1 | Rear Washer Nozzle | - | - |
![]() | Sprayed area | - | - |