BRAKE MASTER CYLINDER (for LHD) > REMOVAL |
| 1. REMOVE CENTER COWL TOP VENTILATOR LOUVER |
![]() |
Disengage the 2 clips and slide the hood to cowl top seal as shown in the illustration.
![]() |
Disengage the 2 claws and separate the washer hose joint.
Disengage the 2 claws and 6 guides remove the cowl top ventilator louver center.
| 2. DRAIN BRAKE FLUID |
| 3. REMOVE BATTERY |
![]() |
Disconnect the cable from the battery terminal.
Loosen the 2 nuts and remove the battery clamp.
Remove the battery.
| 4. REMOVE BATTERY TRAY |
| 5. REMOVE BATTERY CARRIER |
![]() |
Disengage the 6 wire harness clamps and separate the wire harness from the battery carrier.
Remove the 5 bolts and the battery carrier.
| 6. SEPARATE CLUTCH RESERVOIR TUBE (for Manual Transaxle) |
![]() |
Slide the clip and disconnect the clutch reservoir tube.
| 7. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o VSC) |
Disconnect the brake fluid level warning switch connector.
![]() |
Using a union nut wrench 10 mm, separate the 2 brake tubes from the brake master cylinder sub-assembly.
![]() |
Remove the 2 nuts and the brake master cylinder sub-assembly.
Remove the O-ring from the brake master cylinder sub-assembly.
| 8. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ VSC) |
Disconnect the brake fluid level warning switch connector.
![]() |
Using a union nut wrench 12 mm, separate the 2 brake tubes from the brake master cylinder sub-assembly.
![]() |
Remove the 2 nuts and the brake master cylinder sub-assembly.
Remove the O-ring from the brake master cylinder sub-assembly.