BRAKE MASTER CYLINDER (for RHD) > REMOVAL |
| 1. REMOVE CENTER COWL TOP VENTILATOR LOUVER |
![]() |
Disengage the clip and slide the hood to cowl top seal as shown in the illustration.
![]() |
Disengage the 2 claws and separate the washer hose joint.
Disengage the 2 claws and 4 guides and remove the center cowl top ventilator louver.
| 2. DRAIN BRAKE FLUID |
| 3. SEPARATE CLUTCH RESERVOIR TUBE |
![]() |
Slide the clip and separate the clutch reservoir tube.
| 4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o VSC) |
Disconnect the brake fluid level warning switch connector.
![]() |
Using a union nut wrench 10 mm, separate the 2 brake tubes from the brake master cylinder sub-assembly.
![]() |
Remove the bolt.
Disengage the harness clamp and separate the wire harness.
Remove the 2 nuts and brake master cylinder sub-assembly.
Remove the O-ring from the brake master cylinder sub-assembly.
| 5. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ VSC) |
Disconnect the brake fluid level warning switch connector.
![]() |
Using a union nut wrench 12 mm, separate the 2 brake tubes from the brake master cylinder sub-assembly.
![]() |
Remove the bolt.
Disengage the harness clamp and separate the wire harness.
Remove the 2 nuts and the brake master cylinder sub-assembly.
Remove the O-ring from the brake master cylinder sub-assembly.