CLUTCH UNIT > INSPECTION |
| 1. INSPECT CLUTCH DISC ASSEMBLY |
![]() |
Using a vernier caliper, measure the rivet head depth.
![]() |
Install the clutch disc assembly to the manual transaxle assembly.
Using a dial indicator with a roller instrument, measure the clutch disc assembly runout.
| 2. INSPECT CLUTCH COVER ASSEMBLY |
![]() |
Using a vernier caliper, measure the depth and width of the diaphragm spring wear.
| 3. INSPECT FLYWHEEL SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the flywheel sub-assembly runout.
| 4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY |
![]() |
Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.
Inspect the clutch release bearing assembly for damage and wear.
If necessary, replace the clutch release bearing assembly.