FRONT BRAKE > REASSEMBLY |
| 1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG |
| 2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP |
| 3. INSTALL PISTON SEAL |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal as shown in the illustration.
| *1 | Lithium Soap Base Glycol Grease |
Install the piston seal onto the disc brake cylinder.
| 4. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot as shown in the illustration.
| *1 | Lithium Soap Base Glycol Grease |
| *2 | Disc Brake Piston |
| *3 | Cylinder Boot |
Apply a light layer of lithium soap base glycol grease to the entire circumference of the disc brake piston as shown in the illustration.
Install the cylinder boot to the disc brake piston.
Install the disc brake piston to the disc brake cylinder.
| 5. INSTALL CYLINDER BOOT |
![]() |
Install the cylinder boot into the disc brake cylinder.
| *1 | Set Ring |
| *2 | Cylinder Boot |
Using a screwdriver, install a new set ring.