FRONT DOOR > ADJUSTMENT |

| *1 | Centering Bolt |
| *2 | Standard Bolt |
| 1. INSPECT FRONT DOOR |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 3.0 to 6.0 mm (0.118 to 0.232 in.) | F | 3.0 mm (0.118 in.) |
| B | 2.1 to 5.1 mm (0.0826 to 0.200 in.) | G | 3.6 to 6.6 mm (0.141 to 0.259 in.) |
| C | 3.5 to 6.5 mm (0.137 to 0.255 in.) | H | -1.5 to 1.5 mm (-0.0590 to 0.0590 in.) |
| D | 2.9 mm (0.114 in.) | I | 5.5 to 8.5 mm (0.216 to 0.334 in.) |
| E | 3.5 to 6.5 mm (0.137 to 0.255 in.) | J | 5.5 to 8.5 mm (0.216 to 0.334 in.) |
| 2. ADJUST FRONT DOOR |
![]() |
Using SST, adjust the door horizontally and vertically by loosening the body side hinge bolts.
Tighten the body side hinge bolts after the adjustment.
![]() |
Using SST, adjust the door horizontally and vertically by loosening the door side hinge bolts.
Tighten the door side hinge bolts after the adjustment.
![]() |
Using a "TORX" socket wrench T40, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
Using a "TORX" socket wrench T40, tighten the striker mounting screws after the adjustment.