Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > FAIL-SAFE CHART

for Preparation Click here


If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTC Code
Component
Fail-Safe Operation
Fail-Safe Deactivation Condition
P0011
Camshaft Timing Oil Control Valve Assembly
  1. Idle up (Control of combustion worsening)
  2. Stopping fuel-cut control
Pass condition detected
P0031, P0032, P0037 and P0038
Heated oxygen sensor heater
ECM turns off heated oxygen sensor heater.
Ignition switch off
P0100, P0102 and P0103
Mass air flow meter
ECM calculates ignition timing according to engine speed and throttle valve position.
Pass condition detected
P0110, P0112 and P0113
Intake air temperature sensor
ECM estimates intake air temperature to be 20°C (68°F).
Pass condition detected
P0115, P0117 and P0118
Engine coolant temperature sensor
ECM estimates engine coolant temperature to be 80°C (176°F).
Pass condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060D, P060E, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135
Throttle with motor body assembly
ECM cuts off throttle actuator current and throttle valve is returned to 6° throttle position by return spring.
ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal angle to allow vehicle to continue to be driven at minimal speed*.
Pass condition detected and then ignition switch turned off
P0327 and P0328
Knock sensor
ECM sets ignition timing to maximum retard.
Ignition switch off
P0351, P0352, P0353 and P0354
No. 1 ignition coil
ECM cuts fuel.
Pass condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138
Accelerator pedal sensor assembly
Accelerator pedal position sensor has 2 sensor circuits: Main and Sub.
If either circuit malfunctions, ECM controls engine using other circuit.
If both circuits malfunction, ECM regards accelerator pedal as being released. As a result, throttle valve is closed and engine idles.
Pass condition detected and then ignition switch turned off

NOTICE:
*: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.