Home › Drivetrain ยท C54 MANUAL TRANSMISSION / TRANSAXLE › SHIFT LEVER ASSEMBLY

SHIFT LEVER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY
  1. Install the floor shift shift lever assembly with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Install the wire harness to the floor shift shift lever assembly with the 2 clamps.



2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    C195134E01
  1. Rotate the transmission control cable nut counterclockwise 180° and push in the lock while holding the nut.
    Text in Illustration 
    *1
    Nut
    *2
    Lock



    C235548E01
  1. Install the control select cable and the control shift cable to the shift lever plate.
    Text in Illustration 
    *1
    Control Select Cable
    *2
    Control Shift Cable
    *3
    Clip A
    *4
    Clip B
    *5
    Nut
    *6
    Shift Lever Plate

    NOTICE:
    After installation, check that the cable outer lock extends past the line A-A, as shown in the diagram.

  1. Connect the control shift cable to the floor shift shift lever assembly with the clip B.

  1. Connect the control select cable to the floor shift shift lever assembly with the clip A.

    NOTICE:
    Install the cable end adjustment mechanism so that the lock faces the driver seat.



3. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY


    C235560E01
  1. Remove the clip and disconnect the control select cable from the floor shift shift lever assembly.
    Text in Illustration 
    *1
    Control Select Cable



    C235815E01
  1. Slide the adjuster case cover in the direction shown in the illustration.
    Text in Illustration 
    *1
    Adjuster Case Cover



    C241538E01
  1. Pull out the lock piece from the adjuster case.
    Text in Illustration 
    *1
    Lock Piece
    *2
    Adjuster Case
    *3
    Cable Rod

  1. Install the control select cable to the floor shift shift lever assembly with the clip.

    NOTICE:
    1. Make sure to adjust the length at the neutral shift position.
    2. Make sure that the lock piece is protruding from the adjuster case.

  1. Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.

  1. Press the lock piece into the adjuster case and lock it.



    C235819E01
  1. Slide the adjuster case cover in the direction shown in the illustration.
    Text in Illustration 
    *1
    Adjuster Case Cover

    NOTICE:
    Slide the cover past the protrusion portion of the lock piece.



4. INSTALL REAR CONSOLE BOX ASSEMBLY
(Click here)