Home › Drivetrain ยท C54 MANUAL TRANSMISSION / TRANSAXLE › SHIFT LEVER ASSEMBLY

SHIFT LEVER ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


C235167E03
  1. Remove the clip A, and disconnect the control select cable from the floor shift shift lever assembly.
    Text in Illustration 
    *1
    Control Select Cable
    *2
    Control Shift Cable
    *3
    Clip A
    *4
    Clip B
    *5
    Nut
    *6
    Shift Lever Plate
    *a
    Rotate 180°

  1. Disengage the clip B, and disconnect the control shift cable from the floor shift shift lever assembly.

  1. Rotate the nut clockwise approximately 180° and, while holding the nut in that position, separate the control select cable from the shift lever plate.

    NOTICE:
    Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.

  1. Rotate the nut clockwise approximately 180° and, while holding the nut in that position, separate the control shift cable from the shift lever plate.

    NOTICE:
    Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.



3. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY


C235169
  1. Disengage the 2 clamps and separate the wire harness from the floor shift shift lever assembly.

  1. Remove the 4 bolts and the floor shift shift lever assembly.