Home › Engine / Hybrid System ยท 1NZ-FE › EMISSION CONTROL › CANISTER

CANISTER > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK CHARCOAL CANISTER


  1. Inspect the ventilation of the canister.



      A248554E03
    1. Open the fuel tank cap, apply compressed air into port B and check that the air flows out from port A.
      Text in Illustration 
      *a
      Port A
      *b
      Port B
      *c
      Air

      OK:
      The air flows out from the port A.



  1. Inspect the check valve.



      A248555E04
    1. Open the fuel tank cap, close the port A, and apply the compressed air from the port B.
      Text in Illustration 
      *a
      Port A
      *b
      Port B
      *c
      Air

      OK:
      Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches the specified level.



    2. A248556E05
    3. Open the fuel tank cap, close the port A, and apply a vacuum from the port B, using a vacuum pump.
      Text in Illustration 
      *a
      Port A
      *b
      Port B

      OK:
      The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the vacuum decreases after the vacuum reaches the specified level.