Home › Engine / Hybrid System · 1NZ-FE › FUEL › FUEL PUMP

FUEL PUMP > INSPECTION

for Preparation Click here



1. INSPECT FUEL PUMP


    A171358E02
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.2 to 3.0 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Fuel Pump)
      If the result is not as specified, replace the fuel pump.

  1. Check fuel pump operation.

    1. Connect the positive (+) lead of the battery to terminal 1 of the connector and the negative (-) lead to terminal 2. Check that the fuel pump operates.

      NOTICE:
      1. This test must be done quickly (within 10 seconds) to prevent the coil from burning out.
      2. Keep the fuel pump as far away from the battery as possible.
      3. Always switch the voltage on and off at the battery, not the fuel pump.

      If the pump does not operate, replace the fuel pump.