Home › Engine / Hybrid System · 1NZ-FE › FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A246918
  1. Disconnect the fuel sender gauge connector.



    A246961
  1. Release the lock by sliding the fuel sender gauge upward, as shown in the illustration.



2. REMOVE FUEL PUMP HARNESS


    A247519
  1. Disconnect the 2 connectors and remove the fuel pump harness.



3. REMOVE FUEL PUMP FILTER


    A247520
  1. Disengage the 3 claws and remove the fuel pump.

    NOTICE:
    Do not damage the fuel pump filter.



4. REMOVE FUEL PUMP


    A246971
  1. Holding the fuel pump filter by the plastic resin part, remove the fuel pump.

    NOTICE:
    Be careful not to let foreign matter enter the fuel pump or the fuel pump filter.



    A248126E01
  1. Remove the O-ring and fuel pump spacer from the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer
    *a
    (5 mm (0.1969 in.)

    NOTICE:
    Be careful not to damage the sealing surface.

    HINT:
    If the O-ring still remains in the No. 1 fuel suction support, remove it using a wire tip (φ1 mm (0.0394 in.)) that is formed as shown in the illustration.



5. REMOVE NO. 2 FUEL SUCTION SUPPORT


    A247523
  1. Disengage the 3 claws and the clamp as shown in the illustration, and remove the No. 2 fuel suction support from the No. 1 fuel suction support.

    NOTICE:
    Be careful not to damage No. 1 fuel support or No. 2 fuel support.



6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A247524
  1. Remove the fuel pressure regulator assembly from the No. 1 fuel suction support.

    NOTICE:
    1. Be careful not to damage No. 1 fuel suction support.
    2. Make sure that foreign material does not enter the fuel passages of the No. 1 fuel suction support.



7. REMOVE NO. 1 FUEL SUCTION SUPPORT


    A247526
  1. Disengage the 3 claws as shown in the illustration.
    Text in Illustration 
    *a
    Lock

  1. Release the lock, disengage the 2 claws, then slide the No. 1 fuel suction support and remove it.



    A247527
  1. Remove the O-ring from the fuel suction tube assembly.