FUEL PUMP > REASSEMBLY |
| 1. INSTALL NO. 1 FUEL SUCTION SUPPORT |
![]() |
Install a new O-ring to the No. 1 fuel suction support.
![]() |
Engage the 2 claws of the No. 1 fuel suction support guide and the 3 claws of the No. 1 fuel suction support, and install the No. 1 fuel suction support.
| 2. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY |
![]() |
Coat a new O-ring with gasoline and install it to the fuel pressure regulator assembly.
Install the fuel pressure regulator assembly to the No. 1 fuel suction support.
| 3. INSTALL NO. 2 FUEL SUCTION SUPPORT |
![]() |
Align the 3 claws and the clamp, and install the No. 2 fuel suction support.
| 4. INSTALL FUEL PUMP |
![]() |
Holding the fuel pump filter by the plastic resin part, install the fuel pump.
![]() |
Apply gasoline to a new O-ring, and then install the fuel pump spacer and new O-ring onto the fuel pump.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
![]() |
Align the three claws and install the fuel pump filter to the No. 1 fuel suction support.
| 5. INSTALL FUEL PUMP HARNESS |
![]() |
Connect the 2 connectors and install the fuel pump harness.
| 6. INSTALL FUEL SENDER GAUGE ASSEMBLY |
![]() |
Install the fuel sender gauge by sliding it downward.
Connect the fuel sender gauge connector.