Home › Engine / Hybrid System ยท 2NZ-FE › FUEL › FUEL PUMP

FUEL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL NO. 1 FUEL SUCTION SUPPORT


    A247527
  1. Install a new O-ring to the No. 1 fuel suction support.



    A247596
  1. Engage the 2 claws of the No. 1 fuel suction support guide and the 3 claws of the No. 1 fuel suction support, and install the No. 1 fuel suction support.



2. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    A247525
  1. Coat a new O-ring with gasoline and install it to the fuel pressure regulator assembly.

  1. Install the fuel pressure regulator assembly to the No. 1 fuel suction support.



3. INSTALL NO. 2 FUEL SUCTION SUPPORT


    A247523
  1. Align the 3 claws and the clamp, and install the No. 2 fuel suction support.



4. INSTALL FUEL PUMP

HINT:
If the fuel pump has been replaced, conduct Inspection After Repairs (Click here).



    A246972
  1. Holding the fuel pump filter by the plastic resin part, install the fuel pump.

    NOTICE:
    Be careful not to let foreign matter enter the fuel pump or the fuel pump filter.



    A247522E01
  1. Apply gasoline to a new O-ring, and then install the fuel pump spacer and new O-ring onto the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer

    NOTICE:
    Make sure the O-ring is not damaged and has no foreign matter stuck to it.



    A247520
  1. Align the three claws and install the fuel pump filter to the No. 1 fuel suction support.

    NOTICE:
    Do not push the filter part of the fuel filter.



5. INSTALL FUEL PUMP HARNESS


    A247519
  1. Connect the 2 connectors and install the fuel pump harness.



6. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A248137
  1. Install the fuel sender gauge by sliding it downward.

  1. Connect the fuel sender gauge connector.