Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here). (w/ Front Seat Side Airbag)

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.



1. INSTALL FRONT SEAT INNER BELT ASSEMBLY


    B288269E02
  1. Install the front seat inner belt assembly with the bolt. (for 4 Way Seat Type)

    Torque:
    41 N*m{ 420 kgf*cm , 30 ft.*lbf }

    NOTICE:
    Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.

    Text in Illustration 
    *a
    Convex

  1. Engage the clamp. (for 4 Way Seat Type)



    B286794E01
  1. Install the front seat inner belt assembly with the bolt. (for 6 Way Seat Type)

    Torque:
    41 N*m{ 420 kgf*cm , 30 ft.*lbf }

    NOTICE:
    Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.

    Text in Illustration 
    *a
    Convex

  1. Engage the 2 clamps. (for 6 Way Seat Type)

  1. Engage the 5 clamps.

  1. Install the front seat cushion cover with the 4 clips. (for LHD)



2. INSTALL FRONT SEAT ASSEMBLY
(Click here)


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)