Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here). (w/ Front Seat Side Airbag)

HINT:
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.



1. PRECAUTION (w/ Front Seat Side Airbag)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE FRONT SEAT ASSEMBLY
(Click here)


4. REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/ Wire Harness)


    B287108
  1. Disconnect the occupant detection sensor connector.

  1. Remove the 6 clamps.



    B270847
  1. Disengage the clamp.

  1. Remove the bolt and the front seat inner belt assembly.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/o Wire Harness)


    B288294
  1. Remove the bolt and the front seat inner belt assembly.