STEERING COLUMN ASSEMBLY (for LHD) > DISASSEMBLY |
| 1. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY |
![]() |
Place matchmarks on the steering intermediate shaft assembly and the steering sliding yoke.
| *a | Matchmark |
Remove the bolt and the steering sliding yoke from the steering intermediate shaft assembly.
| 2. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
Remove the bolt and No. 2 steering intermediate shaft assembly from the steering column assembly.
| 3. REMOVE TILT STEERING SUPPORT BOND CABLE |
Remove the 2 screws and tilt steering support bond cable.
| 4. REMOVE UPPER STEERING COLUMN BRACKET ASSEMBLY |
Fix the steering column assembly in a vise between aluminum plates.
Using a drill, drill a hole in the steering lock set bolt, to insert a screw extractor.
![]() |
Using the screw extractor, remove the steering lock set bolt and the upper steering column bracket assembly.
| 5. REMOVE UN-LOCK WARNING SWITCH ASSEMBLY |
Insert the key.
![]() |
Remove the un-lock warning switch assembly by releasing the 2 claws.
| 6. REMOVE KEY INTER LOCK SOLENOID (for Automatic Transaxle) |
![]() |
Remove the screw and key inter lock solenoid from the upper steering column bracket assembly.
| 7. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY |
Turn the ignition switch to ACC.
![]() |
Insert the tip of a screwdriver into the hole in the upper steering column bracket assembly, as shown in the illustration, and pull the ignition switch lock cylinder assembly out until its claw comes into contact with the stopper of the upper steering column bracket assembly.
| *1 | Claw |
| *2 | Stopper |
![]() | Push |
![]() | Pull |
![]() |
Insert the tip of a screwdriver into the hole in the steering column bracket and tilt it downward, as shown in the illustration, to disengage the claw on the ignition switch lock cylinder. Then pull out the ignition switch lock cylinder.
| *1 | Claw |
| *2 | Stopper |
| *a | Claw disengaged |
| *b | Driver Insertion Hole |
![]() | Tilt |
![]() | Pull out |
| 8. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY |
![]() |
Disengage the 2 claws and remove the ignition or starter switch assembly from the upper steering column bracket assembly.
| 9. REMOVE POWER STEERING MOTOR ASSEMBLY |
![]() |
Cut the clamp, and remove the clamp and the 3 pieces of tape from the wire harness.
![]() |
Remove the 2 bolts and power steering motor assembly from the electric power steering column sub-assembly.