Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE

SPIRAL CABLE > INSPECTION

for Preparation Click here



1. INSPECT SPIRAL CABLE SUB-ASSEMBLY

NOTICE:
  1. Do not remove the steering sensor from the spiral cable sub-assembly (w/ VSC).
  2. If there is a malfunction in the steering sensor, replace the spiral cable sub-assembly with steering sensor (w/ VSC).

  1. If there are any defects as mentioned below, replace the spiral cable sub-assembly with a new one:

    1. Scratches, cracks, dents or chips on the connector or the spiral cable sub-assembly.



    B282630E01
  1. Inspect the spiral cable sub-assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Spiral Cable Sub-assembly)

    1. Measure the resistance according to the value(s) in the table below.

      NOTICE:
      To avoid breaking the spiral cable sub-assembly, do not turn the spiral cable sub-assembly more than necessary.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      A-1 - C5
      (HO)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      A-2 - C-9
      (SFTU)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      A-3 - C-10
      (SFTD)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      A-6 - C-2
      (ECC)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      A-8 - C-4
      (EAU)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      A-9 - C-5
      (AU2)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      A-10 - C-6
      (AU1)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      B-3 - C-1
      (CCS)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      B-4 - C-2
      (ECC)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      D-1 - E-2
      (D+)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right
      D-2 - E-1
      (D-)
      Center
      Below 1 Ω
      2.5 rotations to the left
      2.5 rotations to the right

      If the value is not within the specified range, replace the spiral cable sub-assembly.